Labels
Hang tag
Hang tag with corner radius and a round hanging hole as an internal cut.
Opens the online editor with this template. Try it without payment details; export with Pro.
- Template
- Hang tag
- Category
- Labels
- Dimension reference
- Nominal size
- Default dimensions
- 50 × 90 × 4 mm
- Parameters
- 3
- Version
- v1
- Template ID
- hangtag
Dimensions and limits
Default dimensions of the template and the permitted range in mm.
| Dimension | Default | Range |
|---|---|---|
| Width | 50 mm | 20–200 mm |
| Height | 90 mm | 20–200 mm |
| Corner radius | 4 mm | 0–∞ mm |
Parameters of this construction
3 parameters with default value and limits, adjustable in the editor.
| Parameter | Default | Range | Note |
|---|---|---|---|
Hole diameterholeDiameter | 5 mm | 2–15 mm | Diameter of the hanging hole; the hole maintains a minimum bridge to the edge. |
Hole distance from topholeDistance | 8 mm | 3–60 mm | Distance from the top edge to the hole center; no more than half the height. |
Horizontal hole positionholePosition | 50 % | 10–90 % | Position of the hole center as a proportion of the width, measured from the left (50 % = centered). |
Assembly
Remove the hang tag from the sheet and thread string, ribbon, or a loop through the hole.
Grain direction
No fixed grain direction; check parallel to the body axis on curved bodies
Reference note
Reference classification still pending
Labels such as “similar to FEFCO” or “ECMA family, unconfirmed” are for orientation only. The templates are our own constructions; an assignment to a standard code is unconfirmed and not a trademark claim.
Frequently asked questions about this template
Where is the hole distance measured from?
holeDistance is the distance of the hole center below the top edge. The starting value is 8 mm. With a 5 mm hole diameter, the upper hole edge is 5.5 mm below the straight top edge. The lateral position is set separately as a proportion of the width.
Can I move the hole sideways?
Yes. holePosition ranges from 10–90 % of the width, measured from the left. The starting value of 50 % is centered. The geometric constraint also checks the minimum bridge to the contour. A position within the parameter range is therefore not automatically permissible near a rounded corner.
How much material must remain around the hole?
The model requires at least 2 mm between the hole edge and outer contour. At rounded corners, the distance is checked against the actual contour. This geometric starting value does not confirm tensile strength. Test the thread, loop, and load with the intended board.
Which material does the hang tag use as its starting profile?
Unlike the paper labels, hangtag uses folding carton board 300 g/m². The profile is a starting value and is not calibrated. No fixed grain direction is specified because the tag has no creases. Confirm material, hole punching, and load capacity using a physical sample.
Related templates
Customise the Hang tag in your browser
Set dimensions and material, review findings and export print-ready as PDF, SVG or DXF.